Set-up-Instructions-Inflatable -Products

Ground Condition Check for sharp objects or debris. DO NOT install over concrete, asphalt, or any hard surfaces to prevent abrasion and impact injuries.

Clearance Zone Maintain at least 2 meters (6.6ft) distance from structures (fences, garages, houses) and overhead obstructions (branches, laundry lines, electrical wires).

• Blower Safety: Keep pump and power cords away from water/moisture. If contact occurs, unplug immediately.
• Electrical Connection: Use an approved grounded outlet. Ensure the switch is in the OFF position before plugging in.
• Tube Alignment: Stretch the inflation tube straight and untwisted. Secure it tightly to the blower output.
• Debris Protection: Keep the blower intake free from leaves or debris to ensure optimal air pressure.

Water Bag System

For models with water bags (e.g., #9082N): Fasten empty bags to sides, fill to 80% capacity (~22kg), and close valves firmly. Mandatory for slide stability.

Ground Stakes

Drive stakes through the blower base and every bouncer loop deep into the soil. This prevents overturning, lifting, or shifting during active play.

Inflation Time: Less than 2 minutes.	Slide Orientation: Facing away from the sun to prevent glare/heat.
Air Flow: Blower must remain ON at all times.	Normal Leakage: Hissing at seams is normal (prevents over-inflation).